Oil Pump: Service and Repair

Oil Pump Replacement

Removal Procedure







1. Remove the oil pan.
2. Remove the bolt attaching the oil pump to the rear crankshaft bearing cap.
3. Remove the oil pump and driveshaft.
4. Inspect the driveshaft at both ends for rounding of the corners.



Installation Procedure






Important: Rotate the driveshaft as necessary in order to obtain the engagement with the oil pump drive unit.

1. Install the oil pump and driveshaft.

Notice: Refer to Fastener Notice in Service Precautions.
Fastener Notice


2. Install the bolt attaching the oil pump to the rear crankshaft bearing cap.
- Tighten the oil pump bolt to 41 Nm (30 ft. lbs.).


3. Install the oil pan.