81. Valve Rocker Arm Cover Installation - Right

Valve Rocker Arm Cover Installation - Right







1. Install the valve rocker arm cover gasket into the valve rocker arm cover.
2. Apply sealer GM P/N United States 12345739, GM P/N Canada 10953541 or the equivalent to the notches where the cylinder head and intake manifold meet.
3. Install the valve rocker arm cover.

Notice: Refer to Fastener Notice in Service Precautions.
Fastener Notice


4. Install the valve rocker arm cover bolts.
- Tighten the valve rocker arm cover bolts to 10 Nm (89 inch lbs.).







5. Install the vacuum lines from the upper intake manifold.







6. Install the ignition coil studs.
- Tighten the ignition coil studs to 25 Nm (18 ft. lbs.).

7. Install the electronic ignition control module.
8. Install the electronic ignition control module nuts and bolts.
- Tighten the electronic ignition control module nuts and bolts to 25 Nm (18 ft. lbs.).

9. Install the spark plug wires.