Head Up Display Module Replacement
HEAD UP DISPLAY MODULE REPLACEMENTREMOVAL PROCEDURE
1. Remove the instrument panel (IP) upper trim panel.
2. Remove the instrument panel cluster (IPC) head up display (HUD) bolts.
3. Disconnect the electrical connector from the HUD.
4. Remove the HUD.
INSTALLATION PROCEDURE
1. Connect the electrical connector to the IPC HUD.
2. Install the HUD.
3. Install the HUD bolts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the bolts to 2 N.m (18 lb in).
4. Install the IP upper trim panel.