Instrument Panel Cluster (IPC) - Replacement

INSTRUMENT PANEL CLUSTER (IPC) REPLACEMENT

REMOVAL PROCEDURE




1. Remove the instrument panel (IPC) cluster trim plate.
2. Remove the IPC screws.
3. Rotate the IPC rearward and lift up on the top of the cluster in order to disengage the locating pins.





4. Disconnect the electrical connectors from the IPC:
- The black electrical connector (1)
- The natural electrical connector (2)
5. Remove the IPC.

INSTALLATION PROCEDURE




1. Connect the electrical connectors to the IPC:
- The black electrical connector (1)
- The natural electrical connector (2)




2. Position the locating pins to the locating pin receivers in the IP.
3. Install the IPC by rotating the top of the IPC inward.
4. Install the IPC screws.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the screws to 2 N.m (18 lb in).

5. Install the IPC trim plate.