Converter

Catalytic Converter Replacement
Removal Procedure

Important: The three way catalytic converter is serviced by replacing the entire assembly. Always replace the gaskets at the front and rear flanges when servicing the three way catalytic converter. Never install the original gasket.

1. Raise and support the vehicle.
2. Disconnect the Heated Oxygen Sensor (H02S) electrical connector.





3. Remove the exhaust manifold pipe stud nuts.
4. Remove the exhaust manifold pipe gasket.
5. Support the exhaust system.





6. Remove the catalytic converter nuts.





7. Remove the catalytic converter hangers.
8. Remove the 3-way catalytic converter.
9. Remove the catalytic converter gasket.
10. Clean and inspect the exhaust manifold and the exhaust pipe gasket mating surfaces.





11. Remove the HO2S.

Installation Procedure





1. Install the Heated Oxygen Sensor (HO2S).

Notice: To prevent internal damage to the flexible coupling of the catalytic converter assembly, the converter must be supported. The vertical movement at the rear of the catalytic converter assembly must not exceed 6 degrees up or down.

2. Install a new gasket to the exhaust pipe studs.
3. Install and support the 3-way catalytic converter.

Notice: Refer to Fastener Notice in Service Precautions.
Fastener Notice






4. Install the catalytic converter nuts.
Tighten the nuts to 60 Nm (44 ft. lbs.).





5. Install a new exhaust manifold pipe gasket.
6. Install the exhaust manifold pipe stud nuts.
Tighten the nuts to 35 Nm (26 ft. lbs.).





7. Install the catalytic converter hangers.
8. Remove the support from the exhaust system.
9. Connect the Heated Oxygen Sensor (HO2S) electrical connector.
10. Inspect the exhaust system for leaks and underbody contact.
11. Lower the vehicle.