Seat Back Bolster Replacement - Rear Split Folding

SEAT BACK BOLSTER REPLACEMENT - REAR SPLIT FOLDING

REMOVAL PROCEDURE
1. Remove the rear seat back.




2. Remove the push-in J-hook retainers from both rear seat bolsters.




3. Pull back the trim on the right bolster in order to expose the rear compartment release handle cable, if equipped.
4. Reposition the compartment release handle cable from the right seat bolster, if equipped.




5. Pull back the seat bolster trim to expose the seat frame bolts.
6. Remove the bolts from the left and/or the right seat bolster.
7. Remove the left and/or the right seat bolster from the seat back frame.




8. Remove the push-in retainers from the center of the bolsters.




9. Remove the push-in tab from the end of the bolsters.




10. Remove the bolster trim covers from the bolsters pads.

INSTALLATION PROCEDURE




1. Install the rear seat bolster trim covers to the rear seat bolster pads.




2. Install the push-in retainers to the center of the bolsters, pressing into place until fully seated.




3. Reposition the trim cover side flap on the bolster under and over the side rail of the seat back frame.
4. Reposition the release handle cable to the right seat bolster, if equipped.




5. Install the bolts to the left and/or the right seat bolsters.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the bolster bolts to 6 N.m (53 lb in).




6. Install the push-in tab from the end of the bolsters, pressing into place until fully seated.




7. Install the push-in J-hook retainers to the bolsters, pressing into place until fully seated.
8. Install the rear seat back.