Rear Camber Adjustment

REAR CAMBER ADJUSTMENT

REMOVAL PROCEDURE




1. Raise the vehicle and provide suitable support. Refer to Vehicle Lifting.
2. Remove the tire and wheel assemblies.
3. Remove the strut from the vehicle.
4. Place the strut in a vise and file the upper strut-to-knuckle hole lateral (oblong). Compare the appearance of the holes before filing (2) with after filing (3).

INSTALLATION PROCEDURE




1. Install the strut to the vehicle.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the strut-to-knuckle bolts as far as to allow movement of the knuckle.

2. Install the tire and wheel assemblies.
3. Adjust the camber (1).

Tighten
Tighten the strut-to-knuckle bolts to 122 Nm (90 lb ft).

4. Lower the vehicle.