Seat Back Cover Replacement - Front With RPO Code AJ7

SEAT BACK COVER REPLACEMENT - FRONT WITH RPO CODE AJ7

REMOVAL PROCEDURE
1. Disable the SIR system.

CAUTION: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling Zones. Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs.

2. Remove the head restraint from the seat back.
3. Remove the seat back from the seat cushion frame.




4. Remove the Side Impact Air Bag (SIAB) module.
5. If equipped, remove the recliner release lever knob (8) from the recliner (11).
6. Unfasten the J-hook retainer (1) located on the bottom of the seat back.
7. Pull the bottom of the seat back cover assembly (2) up and over the frame (7).

INSTALLATION PROCEDURE




1. Pull the bottom of the seat back cover assembly (2) down and over the frame (7).
2. Fasten the J-hook retainer (1) located on the bottom of the seat back.
3. If equipped, install the recliner release lever knob (8) to the recliner (11).
4. Install the Side Impact Air Bag (SIAB) module.
5. Install the seat back to the seat cushion frame.
6. Install the head restraint to the seat back.
7. Enable the SIR system.