Ignition Switch

IGNITION SWITCH REPLACEMENT

REMOVAL PROCEDURE
1. Disconnect the negative battery cable.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
Battery Disconnect Caution


2. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3. Accessories and Optional Equipment/Antitheft and Alarm Systems/Service and Repair/ Service and Repair
3. Remove the steering column trim covers.
4. Remove the ignition lock cylinder.







5. Remove the retaining screws (2) from the ignition switch assembly (3).
6. Remove the ignition switch assembly (3) from the steering column (1).



INSTALLATION PROCEDURE

Ignition Switch Assembly (3) Retaining Screws (2) Steering Column (1):

1. Install the ignition switch assembly (3) to the steering column (1).
2. Install the retaining screws (2) to the ignition switch assembly (3).

NOTE: Refer to Fastener Notice in Service Precautions.
Fastener Notice


Tighten
Tighten the screws to 4 Nm (36 lb in).

3. Install the ignition lock cylinder.
4. Install the steering column trim covers.
5. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3. Accessories and Optional Equipment/Antitheft and Alarm Systems/Service and Repair/ Service and Repair

6. Connect the negative battery cable.