Operation CHARM: Car repair manuals for everyone.

Multifunction, Turn Signal Switch

MULTIFUNCTION, TURN SIGNAL SWITCH REPLACEMENT

REMOVAL PROCEDURE
1. Disconnect the negative battery cable.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
Battery Disconnect Caution

2. Remove the steering column trim covers.







3. Remove the retaining screws from the multifunction switch (2).
4. Remove the multifunction switch (2) from the steering column.
5. Disconnect the electrical connectors from the multifunction switch (2).

INSTALLATION PROCEDURE
1. Connect the electrical connectors to the multifunction switch (2).







2. Install the multifunction switch (2) to the steering column while depressing the spring loaded horn pin.
3. Install the retaining screws to the multifunction switch (2).

NOTE: Refer to Fastener Notice in Service Precautions.
Fastener Notice


Tighten
Tighten the screws to 4 N.m (36 lb in).

4. Install the steering column trim covers.
5. Connect the negative battery cable.
6. Ensure that the multifunction switch functions properly.