On-Vehicle Service

Oil Feed Pipes Replacement

Removal Procedure





1. Remove the transmission oil filter assembly.
2. Remove the oil feed pipe bolts.
3. Inspect the eight oil feed pipe seal rings.
4. Replace the seal rings only if the seal rings are cut, swollen or damaged.





5. Remove the lo and the reverse band oil pipe assembly.
6. Remove the eight lo and the reverse band oil pipe assembly seals.
7. Inspect the oil feed pipes for plugged passages, bent pipes, or cracks.
8. Inspect the oil feed pipe seal rings. Verify the proper location of the seal rings. Replace the seal rings if these are cut, swelled or damaged.

Installation Procedure





1. Install the eight lo and the reverse band oil pipe assembly seals.
2. Install the lo and the reverse band oil feed pipe assembly onto the transmission.

Notice: Refer to Fastener in Service Precautions.





3. Hand start the bolts that attach the oil feed pipe assembly to the transmission.
Tighten the bolts to 12 Nm (106 inch lbs.).
4. Install the transmission oil filter assembly.