Shift Linkage: Service and Repair

Floor Shift Control Replacement

Removal Procedure
1. Disconnect the negative battery cable.





2. Remove the automatic transmission control lever handle retainer.
3. Remove the automatic transmission control lever handle.
4. Remove the console.





5. Remove the range select lever cable from the automatic transmission control.
6. Position aside the park lock cable.
7. Remove the electrical connector.





8. Remove the automatic transmission control nuts.
9. Remove the automatic transmission control.

Installation Procedure
1. Install the automatic transmission control.

Notice: Refer to Fastener Notice in Service Precautions





2. Install the automatic transmission control nuts.
Tighten the nuts to 25 Nm (18 ft. lbs.).
3. Install the electrical connector.
4. Install the park lock cable.





5. Install the range select lever cable to the automatic transmission control.
6. Install the console.





7. Install the automatic transmission control lever handle.
8. Instal the automatic transmission control lever handle retainer.
9. Connect the negative battery cable.