Wiper Arm: Service and Repair
WIPER ARM REPLACEMENTTOOLS REQUIRED
J 39822 Wiper Arm Puller
REMOVAL PROCEDURE
1. Turn the ignition switch to the ACCY position.
2. Turn the wiper switch to the DELAY position.
3. Turn the ignition OFF when the wiper arms are in the innerwipe position and not moving.
4. Mark the position of the wiper arm on the windshield with tape.
5. Disconnect the washer hose from the washer nozzle.
6. Remove the wiper arm nut cover.
7. Remove the wiper arm nut.
8. Using the J 39822 , remove the wiper arm from the wiper transmission.
INSTALLATION PROCEDURE
1. Position the wiper arm onto the wiper transmission.
2. Align the wiper arm to the tape marks on the windshield.
3. Install the wiper arm nut.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the nut to 30 N.m (22 lb ft).
4. Install the wiper arm nut cover.
5. Connect the washer hose to the washer nozzle.
6. Remove the tape marks from the windshield.
7. Inspect the wipers for proper operation.