Wiper Gear Box: Service and Repair
WIPER TRANSMISSION REPLACEMENTTOOLS REQUIRED
- J 39232 Wiper Transmission Separator
- J 39529 Wiper Transmission Installer
REMOVAL PROCEDURE
1. Remove the air inlet grille panel.
2. Disconnect the wiper motor electrical connector.
3. Remove the wiper drive system module screws.
4. Remove the wiper drive system module from the vehicle.
5. Using the J 39232 , disconnect the wiper transmission from the wiper motor crank arm.
6. Remove the wiper transmission caps.
7. Remove the wiper transmission screws.
8. Remove the wiper transmission from the wiper drive system module tube frame.
INSTALLATION PROCEDURE
1. Position the wiper transmission to the wiper drive system module tube frame.
2. Install the wiper transmission screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screws to 9 N.m (79 lb in).
3. Install the wiper transmission caps.
4. Using the J 39529 , connect the wiper transmission to the wiper motor crank arm.
5. Position the wiper drive system module to the vehicle.
6. Install the wiper drive system module screws.
Tighten
Tighten the screws to 10 N.m (89 lb in).
7. Connect the wiper motor electrical connector.
8. Install the air inlet grille panel.
9. Inspect the wipers for proper operation.