Radio/Stereo: Service and Repair
RADIO REPLACEMENTREMOVAL PROCEDURE
1. Remove the IP accessory center trim plate.
2. Remove the 4 screws (1) which secure the radio (2).
3. Disconnect the clamp (4) from the radio receiver bracket (3).
4. Pull the radio (2) from the instrument panel.
5. Disconnect the following from the radio:
- The electrical connector
- The antenna lead (1)
INSTALLATION PROCEDURE
1. Connect the radio electrical connector.
2. Connect the antenna lead (1) to the radio (2).
3. Install the radio (2) to the instrument panel. Secure the radio with the 4 screws (1).
4. Install the IP accessory center trim plate.