Inflatable Restraint Instrument Panel Module Replacement

REMOVAL PROCEDURE




1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 5.

CAUTION: Refer to SIR Inflator Module Handling and Storage Caution in Service Precautions.

2. Remove the instrument panel (I/P) compartment (2).




3. Disconnect the I/P module connector (1).




4. Remove the I/P module fasteners (2,3).
5. Remove the inflatable restraint I/P module (1).
6. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping.

INSTALLATION PROCEDURE




1. Install the inflatable restraint I/P module (1).
2. Install the mounting fasteners (2,3) to the I/P module.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten fasteners to 20 N.m (15 lb ft).




3. Connect the I/P module connector (1).




4. Install the I/P compartment (2).
5. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 5.