Wiper Motor Replacement
WIPER MOTOR REPLACEMENTREMOVAL PROCEDURE
1. Remove the wiper arms.
2. Remove the air inlet grille panel.
3. Disconnect the wiper motor electrical connector (1).
4. Remove the 2 wiper motor assembly bolts (2).
5. Remove the wiper motor assembly (3) from the engine compartment.
6. Remove the wiper transmission.
INSTALLATION PROCEDURE
1. Position the wiper motor assembly (3) to the cowl.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the wiper motor transmission.
3. Install the 2 wiper motor assembly bolts (2).
Tighten
Tighten the bolts to 5.5 N.m (48 lb in).
4. Connect the wiper motor electrical connector (1).
5. Install the air inlet grille panel.
6. Install the wiper arms.