Operation CHARM: Car repair manuals for everyone.

C0246

DTC C0226-C0256:





DTC C0226-C0256

Circuit Description
The solenoid valves are part of the brake pressure modulator valve (BPMV). The BPMV turns ON and OFF the solenoid valves as deemed necessary to modulate hydraulic pressure to the wheel brakes during an antilock brake system (ABS) stop.

Conditions for Running the DTC
DTC's C0226 - C0256 can be set anytime the ignition switch is in the ON position.

Conditions for Setting the DTC
The electronic brake control module (EBCM) detects one of the following conditions in the solenoid circuitry:
^ An open
^ A short to ground
^ A short to voltage

Action Taken When the DTC Sets
^ The ABS is disabled.
^ The ABS warning indicator turns ON.

Conditions for Clearing the DTC
The condition responsible for setting the DTC no longer exists and the Scan Tool Clear DTCs function is used.

Diagnostic Aids
Thoroughly inspect the wiring and the connectors. An incomplete inspection of the wiring and the connectors may result in a misdiagnosis, causing a part replacement with the reappearance of the malfunction.

The following are possible causes of the malfunction:
^ An open, high resistance, or a short to ground in the battery positive voltage circuits
^ An open or high resistance in the solenoid ground circuit
^ An internal EBCM malfunction
If an intermittent malfunction exists, refer to Testing for Intermittent and Poor Connections in Symptoms. A Symptoms - Antilock Brake System

Test Description
The numbers below refer to step numbers on the diagnostic table.
4. This step determines if the DTC is current.