Rear Suspension

Wheel Bearing/Hub Replacement Rear (FWD)

Removal Procedure
1. If the vehicle has rear disc brakes, remove the rear brake rotor.
2. If the vehicle has rear drum brakes, remove the brake drum.







3. If the vehicle has ABS, disconnect the rear wheel speed sensor connector (3). Position the connector to the side.
4. Remove the 4 bolts (1, 2, 4, 5).
5. Remove the wheel bearing and hub assembly.



Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.
Fastener Notice







1. Install the wheel bearing and hub assembly and the 4 bolts (1, 2, 4, 5).
Tighten the bolts to 61 Nm (45.0 ft. lbs.).

2. Connect the rear wheel speed sensor connector (3).
3. If the vehicle has rear drum brakes, install the brake drum,
4. If the vehicle has rear disc brakes, install the rear brake rotor.
5. Perform the Diagnostic System Check - ABS. Diagnostic System Check