Instrument Panel Module Replacement
INSTRUMENT PANEL MODULE REPLACEMENTREMOVAL PROCEDURE
1. Remove the left sound insulator.
2. Remove the fastener (2) from the Instrument Panel Module (IPM).
3. Rotate the IPM up and out of the IP retainer.
4. Disconnect the electrical connectors from the IPM (1).
INSTALLATION PROCEDURE
1. Connect the electrical connectors to the IPM (1).
2. Install the IPM (1) to the IP retainer by inserting the top tab of the module into the slot on the IP retainer and rotating down.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the fastener.
Tighten
Tighten the fastener to 2 N.m (18 lb in).
4. Install the left sound insulator.
5. Reprogram the IPM. Refer to Body Control Module (BCM) Programming/RPO Configuration (IPM)Body Control Module (BCM) Programming/RPO Configuration (DIM)Body Control Module (BCM) Programming/RPO Configuration (RIM). Programming and Relearning