80. Cylinder Head Installation - Right

Cylinder Head Installation - Right

^ Tools Required
- J 45059 Angle Meter





1. Install the cylinder head gasket. Ensure the arrows point towards the front of the engine. The right cylinder head gasket has the letter R stamped next to the arrow.
2. Install the cylinder head.






Notice: Refer to Special Fastener Notice in Service Precautions.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install new cylinder head bolts.
^ Tighten the cylinder head bolts to 50 Nm (37 ft. lbs.) in sequence. Using J 45059 rotate each cylinder head bolt an additional 120 degrees.