Blower Motor Control Processor Replacement

BLOWER MOTOR CONTROL PROCESSOR REPLACEMENT

REMOVAL PROCEDURE
1. Remove the right sound insulator.
2. Remove the instrument panel compartment.
3. Remove the Dash Integration Module (DIM) from the bracket and position aside.
4. Remove the rear DIM bracket screws and lower the bracket enough to access the blower module.




5. Disconnect the electrical connector (1).
6. Remove the blower control module retaining screw.
7. Remove the blower control module.

INSTALLATION PROCEDURE
1. Install the blower control module.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the retaining screw.

Tighten
Tighten the bolt to 2 N.m (18 lb in).




3. Connect the electrical connector (1).
4. Install the DIM bracket screws.

Tighten
Tighten the bolt to 1.4 N.m (12 lb in).

5. Install the DIM into the bracket.
6. Install the instrument panel compartment.
7. Install the right sound insulator.