Rear

Wheel Bearing/Hub Replacement - Rear

Removal Procedure





1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the brake rotor. Refer to Brake Rotor Replacement - Rear in Disc Brakes.
4. Disconnect the wheel bearing/hub ABS harness connector.
5. Remove the wheel bearing/hub retaining bolts.
6. Remove the wheel bearing/hub from the lower control arm.
7. Remove the brake shield from the lower control arm.
8. Clean the control arm face and the bore before installing the hub and the bearing.

Installation Procedure





1. Install the brake shield and the wheel bearing/hub to the lower control arm.

Notice Refer to Fastener Notice in Service Precautions.

2. Install the wheel bearing/hub retaining bolts.
^ Tighten the wheel bearing/hub bolts to 70 Nm (52 ft. lbs.).
3. Connect the wheel bearing/hub ABS harness connector.
4. Install the brake rotor. Refer to Brake Caliper Replacement - Rear in Disc Brakes.
5. Install the tire and Wheel.
6. Lower the vehicle.