Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring

Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement

^ Tools Required
- J 23653-SIR Steering Column Lock Plate Compressor

Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.





1. Disable the SIR system.
2. Remove the knee bolster
3. Remove the steering wheel.
4. Remove the SIR coil.
5. Remove the steering column trim covers.
6. Using J 23653-SIR remove the bearing retainer.





7. Remove the shaft lock shield assembly (1).
8. Remove the turn signal cancel cam assembly (2).
9. Remove the upper bearing spring (3).

Installation Procedure





1. Install the upper bearing spring (3).
2. Install the turn signal cancel cam assembly (2).
3. Install the shaft lock shield assembly (1).
4. Install the bearing retainer.





5. Using J 23653-SIR depress the shaft lock shield assembly.
6. Push the bearing retainer into place.
7. Remove J 23653-SIR from the steering shaft.
8. Install the steering column trim covers.
9. Install the SIR coil.
10. Install the steering wheel.
11. Install the knee bolster.
12. Enable the SIR system.