Front Seat Recliner Replacement (Power)

Front Seat Recliner Replacement (Power)

Removal Procedure

1. Position the seat to the full forward position.
2. Remove the seat.
3. Remove the seat cushion.
4. Disconnect the lumbar electrical connector.
5. Remove the adjuster track covers.
6. Remove the seat back frame.
7. Remove the seat back recliner motor and sensor, if equipped.




8. Remove the fasteners securing the outboard seat adjuster track reinforcement bracket.
9. Remove the outboard seat adjuster track reinforcement bracket.
10. Remove the seat back recliner fasteners.
11. Remove the recliner assemblies by sliding the recliners rearwards out of the seat adjuster tracks.

Installation Procedure

1. Slide the recliner assemblies into the seat adjuster tracks.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the recliner fasteners.

Tighten the fasteners to 50 N.m (37 lb ft).




3. Install the outboard seat adjuster track reinforcement bracket.
4. Install the reinforcement bracket fasteners.

Tighten the fasteners to 50 N.m (37 lb ft).

5. Install the recliner motor and sensor if equipped.
6. Install the seat back frame.
7. Connect the lumbar electrical connector.
8. Install the adjuster track covers.
9. Install the seat cushion.
10. Install the seat.