Ignition Control Module Replacement - Bank 2

IGNITION CONTROL MODULE REPLACEMENT - BANK 2

REMOVAL PROCEDURE




1. Remove the ignition cassette.
2. Remove the ignition control module retaining screws.
3. Remove the ignition control module.

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Service Precautions.




1. Install the ignition control module. Install the ignition control module retaining screws.

Tighten the ignition control module retaining screws to 0.8 N.m (7 lb in).

IMPORTANT Be sure the ignition cassette grounding spring and insulator are in place when installing the ignition cassette.

Connect the spark plug boots to the spark plugs.

2. Install the ignition cassette.