Inflatable Restraint Sensing and Diagnostic Module (AM6)

INFLATABLE RESTRAINT SENSING AND DIAGNOSTIC MODULE REPLACEMENT (AM6)

REMOVAL PROCEDURE

CAUTION:
- Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
- If the vehicle interior is exposed to moisture and becomes soaked up to the level of the sensing and diagnostic module (SDM), the SDM and SDM harness connector must be replaced. The SDM could be activated when powered, which could cause airbag deployment and result in personal injury.

1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 7 , SIR Disabling and Enabling Zone 8 and to SIR Disabling and Enabling Zone 9.




2. Remove the front split bench seat.
3. Remove the rear carpet from vehicle.




4. Remove the connector position assurance (CPA) (1) from the inflatable restraint sensing and diagnostic module (SDM) wiring harness connector (2).
5. Push down the flex lock button (3) and then move the sliding connector locking cover (4) to the open position.




6. Remove the push-on clip (1) securing the SDM wiring harness to the console stud.
7. Disconnect the SDM wiring harness connector (3) from the SDM (2).




8. Remove the SDM mounting fasteners (1).
9. Remove the SDM (2) from the console floor (3).

INSTALLATION PROCEDURE
1. Remove any dirt, grease, or other impurities from the mounting surface.




2. Install the SDM (2) horizontally to the console floor (3).
3. Point the arrow on the SDM toward the front of the vehicle.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the SDM mounting fasteners (1).

Tighten
Tighten fasteners to 9 N.m (80 lb in).




5. Connect the SDM wiring harness connector (3) to the SDM (2).
6. Install the push-on clip (1) securing the SDM wiring harness to the console stud.




7. Push down the flex lock button (3) and then move the sliding connector locking cover (4) to the close position.
8. Install the CPA (1) to the inflatable restraint SDM wiring harness connector (2).




9. Install the rear carpet into the vehicle.
10. Install the front split bench seat.
11. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7 , SIR Disabling and Enabling Zone 8 and SIR Disabling and Enabling Zone 9.

IMPORTANT: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps thoroughly to ensure that the SDM is set properly.

12. Program the new SDM into the dash integration module. Programming and Relearning