Wiper Switch: Service and Repair

WIPERS/WASHER SWITCH REPLACEMENT

REMOVAL PROCEDURE

CAUTION: Refer to SIR Caution in Service Precautions.




1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Restraint Systems.
2. Remove the steering column bracket.
3. Remove the steering column trim covers.
4. Remove the wire harness assembly from the wire restraint clips (1).
5. Disconnect the wire connector.




6. Disconnect the windshield wiper and washer switch assembly.
7. Remove the switch assembly in the following manner.
7.1. Press on the locking tabs of the switch assembly.
7.2. Pull the switch assembly out of the switch mounting bracket.

IMPORTANT: To remove the side mounted bracket perform the following steps. If not a side mounted bracket go to step 10.




8. Remove the 2 pan head tapping screws (1).
9. Remove the switch mounting bracket (2).

IMPORTANT: To remove the slide on mounting bracket perform the following steps.




10. Remove the turn signal cancel cam and steering shaft upper bearing spring.
11. Remove the turn signal and multifunction switch assembly only.
12. Slide the switch mounting bracket off of the steering column shaft assembly.

INSTALLATION PROCEDURE




1. Install the side mounted switch mounting bracket (2) to the steering column tilt head assembly. If not a side mounted bracket go to step 3.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the 2 pan head tapping screws (1).

Tighten
Tighten the screws to 7 N.m (62 lb in).

3. To install the windshield washer and wiper switch assembly go to step 7.

IMPORTANT: The switch mounting bracket must be pressed firmly against the steering column tilt head in order for the screws from the turn signal and multifunction switch assembly screws to line up.




4. Slide the switch mounting bracket onto the steering column shaft assembly.
5. Install the turn signal and multifunction switch assembly only.
6. Install the turn signal cancel cam and steering shaft upper bearing spring.




7. If necessary, install the switch assembly into the switch mounting bracket so that the locking tabs snap into place.
8. Connect the wire harness assembly.




9. Install new wire harness straps.
10. Install the wire harness assembly into the wire restraint clips (1).
11. Install the steering column trim covers.
12. Install the steering column bracket.
13. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Restraint Systems.