Instrument Panel (IP) - End Bracket Replacement - Right

Bracket Replacement - Instrument Panel (I/P) End Right

Removal Procedure

1. Remove the instrument panel pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper (Service and Repair) .
2. Remove the body control module. Refer to Body Control Module Replacement in Body Control System.




3. Remove the screw (1) attaching the right end bracket assembly (2) to the lower radio bracket.
4. Remove the bolt (6) attaching the right end bracket assembly (2) to the lower radio bracket.
5. Remove the bolts (3) and (4) attaching the right end bracket assembly (2) to the vehicle.
6. Remove the two bolts (5) attaching the right end bracket (2) to the instrument panel inflatable restraint.
7. Detach the wiring harness and remove the right end bracket assembly (2) from the vehicle.



Installation Procedure





1. Position the right end bracket assembly (2) to the vehicle and attach the wiring harness.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the 2 bolts (5) attaching the right end bracket (2) to the instrument panel inflatable restraint.

Tighten the bolts to 9 N.m (80 lb in).

3. Install the bolts (3) and (4) attaching the right end bracket assembly (2) to the vehicle.

Tighten the bolts to 9 N.m (80 lb in).

4. Install the bolt (6) attaching the right end bracket assembly (2) to the lower radio bracket.

Tighten the bolt to 9 N.m (80 lb in).

5. Install the screw (1) attaching the right end bracket assembly (2) to the lower radio bracket.

Tighten the screw to 2 N.m (18 lb in).

6. Install the body control module. Refer to Body Control Module Replacement in Body Control System.
7. Install the instrument panel pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper (Service and Repair) .