Traction Control Indicator Always On

Traction Control Indicator Always On

Step 1-5:

Circuit Description
The TCS OFF Indicator is controlled by the Electronic Brake Control Module (EBCM) by sending a signal to the Instrument Panel Cluster (IPC). It is turned on when the EBCM sets a DTC that turns on the TCS OFF indicator. It is also turned on or off when the Control Switch is pressed. The EBCM supplies 12 volts to the Traction Control Switch, when the TCS switch is depressed the EBCM sees the voltage go low, and that the TCS switch state has changed. When the EBCM receives that a switch state has changed it turns on or off the Traction Control and sends a message to the IPC to turn on or off the TCS OFF indicator depending on its previous state.

Diagnostic Aids
Thoroughly inspect the wiring and the connectors. An incomplete inspection of the wiring and the connectors may result in a misdiagnosis, causing a part replacement with the reappearance of the malfunction. The following are possible causes of the malfunction:
- An internal EBCM malfunction
- An internal IPC malfunction If an intermittent malfunction exists, refer to Testing for Intermittent and Poor Connections Diagnostic Aids.

Test Description
The numbers in the image, refer to step numbers on the diagnostic table.
2. This step tests the operation of the Trac Off indicator lamp circuit.