Fog/Driving Lamp Bulb: Service and Repair

Fog Lamp Bulb Replacement - Front







Removal Procedure

Caution: Refer to Halogen Bulb Caution in Cautions and Notices.
Halogen Bulb Caution


1. Raise and support the vehicle.
2. Remove the lower grille.
3. Remove the screw (1) to release the clamp ring (4).
4. Rotate the ring (4) clockwise until the retaining hook (3) is at the 9 o'clock position.
5. Ease the ring (4) out of the aperture and away from the fog lamp (2).







6. Pull the lens and reflector assembly (1) away from the fog lamp housing (5).
7. Disconnect the bulb lead (4) from the wiring harness connector located inside the insulation sheath (6).
8. Squeeze the two halves of the spring retainer (2) together and pivot the spring backward clear of the bulb (3)
9. Remove the bulb (3) from the lens and reflector assembly (1).










Installation Procedure
1. Install the fog lamp bulb (3) into the correct locating notches in the reflector and insert the spring retainer (2).
2. Connect the bulb lead (4) to the wiring harness connector inside the sheath (6).
3. Install the lens and reflector assembly (1) into the housing (5), ensuring that the tabs on the rim of the lens and reflector assembly (1) correspond with the cut-outs in the rim of the housing (5).









4. Position the clamp ring (4) to the fog lamp (2).

Notice: Refer to Fastener Notice in Cautions and Notices.
Fastener Notice

5. Install the screw (1) to the clamp ring (4).


Tighten the screw to 1 N.m (9 lb in)

6. Lower the vehicle.
7. Aim fog lamps, if required.
8. Install the lower grille.