Throttle Position Sensor: Service and Repair

Throttle Position (TP) Sensor Replacement


Removal Procedure

Notice: The TP sensor is an electrical component. Do not soak the TP sensor in any liquid cleaner or solvent as damage may result.

1. Depress the power steering reservoir retaining clip and lift it up on the reservoir and set aside.

2. Unbolt and remove the power steering reservoir mounting bracket.
3. Disconnect the TP sensor electrical connector.

4. Remove the TP sensor attaching screws (5).

5. Remove the TP sensor (6).

6. Remove the TP sensor 0-ring seal (7).






Installation Procedure

1. Install the TP sensor 0-ring seal (7) on the TP sensor (6).

2. Install the TP sensor (6) on the throttle body (1) with the throttle valve in the closed position. Ensure that the TP sensor lever lines up with the TP sensor drive lever on the throttle shaft.

Notice: Refer to the Fastener Notice in Cautions and Notices.

3. Install the TP sensor attaching screws (5). Tighten the TP sensor attaching screws to 2 Nm (18 lb in).

4. Connect the TP sensor electrical connector.

5. Install the power steering reservoir mounting bracket.

6. Install the power steering reservoir to the mounting bracket.