Automatic Transmission/Transaxle: Adjustments

Park/Neutral Position Switch Adjustment





1. Raise and suitably support the vehicle.
2. install the PNP switch on the transmission.
3. Install the PNP switch retaining bolts (6) finger tight only at this time.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the selector lever and nut on the manual selector shaft.
^ Tighten the retaining nut to 25 Nm (18 ft. lbs.).
5. Slightly rotate the PNP switch back and forth until a central position is obtained, then lightly tighten the front bolt.
6. Connect the PNP switch electrical connector (2).
7. Install the PNP wiring harness electrical connector, do not install the securing pin at this time.
8. Ensure that the engine can only be started in the Park and Neutral positions. Adjust the switch as necessary.
9. Tighten the retaining bolts.
^ Tighten the retaining bolts to 25 Nm (18 ft. lbs.).
10. Compress the electrical connector release clip, then install the securing pin.
11. Lower the vehicle.
12. Ensure that the engine can only be started in the Park and Neutral positions.
13. Check the reverse lamps for proper operation.