B1374
DTC B1374CIRCUIT DESCRIPTION
The BCM uses a input from the ignition switch to determine the power mode that the vehicle is in, this input is ignition 1. When the BCM senses that ignition 1 is inactive when ignition 0 and 3 are active and the engine is running, DTC B1374 is set.
CONDITIONS FOR RUNNING THE DTC
- The engine is running.
- At least 20 seconds has elapsed since the engine was started.
CONDITIONS FOR SETTING THE DTC
The ignition 1 input is inactive after the engine has been running for 20 seconds.
ACTION TAKEN WHEN THE DTC SETS
- The SERVICE VEHICLE SOON indicator illuminates.
- The check gages chime sounds.
CONDITIONS FOR CLEARING THE DTC
- A current DTC B1374 will clear when the code setting condition is no longer present and the ignition switch is cycled.
- A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.
DIAGNOSTIC AIDS
If the DTC is a history DTC, the problem may be intermittent. Perform the tests shown while wiggling the wiring and connectors. This can often cause the malfunction to appear.
TEST DESCRIPTION
Steps 1 - 5:
Steps 6 - 10:
Steps 11 - 12:
The numbers below refer to the step numbers on the diagnostic table.
4. This step determines if the ignition 1 circuit is shorted to ground.
5. This step determines if the BCM is internally shorted.
6. This step determines if voltage is supplied from the battery to the fuse.