Front

Wheel Bearing/Hub Replacement - Front

Removal Procedure





1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.
3. Remove the wheel drive shaft nut.
4. Remove the brake rotor.
5. Disconnect the ABS sensor harness connector from the retaining bracket and wiring harness.
6. Remove the hub and bearing assembly bolts.
7. Remove the hub and bearing assembly from the steering knuckle.

Installation Procedure





1. Install the hub and bearing assembly to the steering knuckle.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the hub and bearing assembly bolts.
^ Tighten the hub and bearing assembly bolts to 95 Nm (70 ft. lbs.).
3. Connect the ABS sensor harness connector from the retaining bracket and wiring harness.
4. Install the brake rotor.
5. Install the wheel drive shaft nut.
6. Install the tire and wheel assemblies.
7. Check the front wheel alignment.