Oil Level Sensor: Service and Repair

Engine Oil Level Sensor and/or Switch Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Drain the oil from the oil pan.





3. Disconnect the electrical connector from the oil level sensor.





4. Remove the oil level sensor bolt.
5. Remove the oil level sensor from the oil pan.

Installation Procedure





1. Install the oil level sensor to the oil pan.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the oil level sensor bolt.
^ Tighten the bolt to 10 Nm (7 ft. lbs.).





3. Connect the electrical connector to the oil level sensor.
4. Lower the vehicle.
5. Ensure that the engine oil is filled to the proper level.