P1133
DTC P1133CIRCUIT DESCRIPTION
Heated oxygen sensors (HO2S) are used for fuel control and post catalyst monitoring. Each HO2S compares the oxygen content of the surrounding air with the oxygen content of the exhaust stream. When the vehicle is first started, the powertrain control module (PCM) operates in an Open Loop mode, ignoring the HO2S signal voltage when calculating the air-to-fuel ratio. The PCM supplies the HO2S with a reference or bias voltage of about 450 mV. The HO2S generates a voltage within a range of 0-1,00O mV that fluctuates above and below bias voltage once the sensor reaches operating temperature. A high HO2S voltage output indicates a rich fuel mixture. A low HO2S voltage output indicates a lean mixture. Heating elements inside the HO2S minimize the time required for the sensors to reach operating temperature and provide an accurate voltage signal. This DTC runs once per ignition cycle. If the PCM detects that the HO2S 1 voltage did not switch enough times during a calibrated time period, DTC P1133 will set.
Each HO2S 1 has the following circuits:
- An HO2S 1 high signal circuit
- An HO2S 1 low signal circuit
- An HO2S 1 heater ignition 1 voltage circuit
- An HO2S 1 heater low control circuit
CONDITIONS FOR RUNNING THE DTC
- DTCs P0030, P0036, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0134, P0135, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0300, P0442, P0443, P0446, P0449, P0455, P0496, P1106, P1107, P1111, P1112, P1114, P1115, P2135 are not set.
- DTCs P0136, P0401, and P0420 passed.
- The vehicle is not in Park, Reverse, or Neutral.
- The Engine Run Time parameter is at least 60 seconds.
- The Loop Status parameter is closed.
- The MAF sensor parameter is between 15-31 g/s.
- The HO2S heater is enabled.
- The evaporative emissions (EVAP) purge is active.
- The TP Indicated Angle parameter is varying less than 2 percent.
- The Engine Speed parameter is between 1,300-3,150 RPM.
- The ECT Sensor parameter is more than 60°C (140°F).
- The system voltage is between 9-18 volts.
CONDITIONS FOR SETTING THE DTC
The PCM detects that the HO2S 1 voltage had fewer rich to lean switches than a calibrated value during a 90 second monitoring period.
OR
The PCM detects that the HO2S 1 voltage had fewer lean-to-rich switches than a calibrated value during a 90 second monitoring period.
ACTION TAKEN WHEN THE DTC SETS
- The control module illuminates the malfunction indicator lamp (MIL) on the second consecutive ignition cycle that the diagnostic runs and fails.
- The control module records the operating conditions at the time the diagnostic fails. The first time the diagnostic fails, the control module stores this information in the Failure Records. If the diagnostic reports a failure on the second consecutive ignition cycle, the control module records the operating conditions at the time of the failure. The control module writes the operating conditions to the Freeze Frame and updates the Failure Records.
CONDITIONS FOR CLEARING THE MIL/DTC
- The control module turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
- A current DTC, Last Test Failed, clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
- Clear the MIL and the DTC with a scan tool.
TEST