Procedures
MIRROR, WINDOW, AND DOOR LOCK SWITCH REPLACEMENTREMOVAL PROCEDURE
IMPORTANT: When removing a power window switch, the ignition switch must be in the OFF position. This will eliminate the possibility of shorting out the power window switch when using a metal tool to remove the power window switch from the wiring harness.
1. Remove the door trim panel.
2. Disengage the electrical connectors from the following switches:
- Rear compartment lid switch (1)
- The power window switch (2)
- The door lock switch (3)
- The power mirror switch(4)
3. Remove the electrical harness from the trim panel.
4. Using a small, flat-bladed tool, remove the switches from the mounting bezel.
INSTALLATION PROCEDURE
1. Install the following switches into the mounting bezel:
- Rear compartment lid switch
- The power window switch
- The door lock switch
- The power mirror switch
2. Position the trim panel electrical harness on the trim panel.
3. Connect the electrical connectors to the switches.
4. Install the door trim panel.