Instrument Panel (IP) - Accessory Trim Plate Replacement

Trim Plate Replacement - Instrument Panel (I/P) Accessory

Removal Procedure





1. Use a plastic trim tool to remove the ignition switch bezel.




2. Pull the instrument panel (I/P) accessory trim plate rearward.




3. Disconnect the electrical connector from the driver information display assembly.
4. Remove the driver information display screws.
5. Remove the driver information display.




6. Remove the I/P center air outlet screws.
7. Remove the I/P center air outlet.
8. Remove the I/P accessory trim plate.



Installation Procedure





1. Position the I/P center air outlet to the I/P accessory trim plate.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the I/P center air outlet screws.

Tighten the screws to 2 N.m (18 lb in).





3. Place the driver information display on the I/P accessory trim plate
4. Install the driver information display screws.

Tighten the screws to 2 N.m (18 lb in).

5. Connect the electrical connector to the driver information display.




6. Press the I/P accessory trim plate to the I/P.




7. Install the ignition switch bezel.