Instrument Panel Cluster (IPC) - Replacement

INSTRUMENT PANEL CLUSTER (IPC) REPLACEMENT

REMOVAL PROCEDURE

IMPORTANT: The ignition switch must be in the OFF position when removing the instrument cluster.




1. Remove the instrument panel (I/P) cluster trim plate.
2. Remove the instrument cluster screws.
3. Pull the instrument cluster towards you and disconnect the electrical connector.
4. Remove the instrument cluster.

INSTALLATION PROCEDURE




1. Connect the electrical connector to the instrument cluster.
2. Align the instrument cluster to the I/P.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the instrument cluster screws.

Tighten
Tighten the instrument cluster screws to 2 N.m(18 lb.in).

4. Install the I/P cluster trim plate.
5. If a new instrument cluster was installed, program the cluster. Refer to Service Programming System (SPS in Programming.