EGR Boost Control Solenoid: Service and Repair

BOOST CONTROL SOLENOID REPLACEMENT

REMOVAL PROCEDURE




1. Remove the fuel injector sight shield.
2. Disconnect the boost source signal hose (3) from the boost control solenoid (4).
3. Disconnect the boost control solenoid electrical connector.
4. Remove the boost control solenoid nut (1).
5. Remove the boost control solenoid (4).

INSTALLATION PROCEDURE




1. Install the boost control solenoid (4).

NOTE: Refer to Fastener Note in Service Precautions.

2. Install the boost control solenoid nut (1).

Tighten
Tighten the nut to 10 N.m (89 lb in).

3. Connect the boost control solenoid electrical connector.
4. Connect the boost source signal hose (3) to the boost control solenoid (4).
5. Install the fuel injector sight shield.