Removal and Replacement

Mirror, Window, and Door Lock Switch Replacement

Removal Procedure


Important: When removing a power window switch, the ignition switch must be in the OFF position. This will eliminate the possibility of shorting out the power window switch when using a metal tool to remove the power window switch from the wiring harness.


1. Remove the door trim panel. Refer to Trim Panel Replacement - Side Front Door (Service and Repair) .




2. Disengage the electrical connectors from the following switches:

* Rear compartment lid switch (1)
* The power window switch (2)
* The door lock switch (3)
* The power mirror switch(4)

3. Remove the electrical harness from the trim panel.




4. Using a small, flat-bladed tool, remove the switches from the mounting bezel.



Installation Procedure





1. Install the following switches into the mounting bezel:

* Rear compartment lid switch
* The power window switch
* The door lock switch
* The power mirror switch





2. Position the trim panel electrical harness on the trim panel.
3. Connect the electrical connectors to the switches.
4. Install the door trim panel. Refer to Trim Panel Replacement - Side Front Door (Service and Repair) .