Automatic Transmission Mount Bracket Replacement
Automatic Transmission Mount Bracket ReplacementRemoval Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the left front tire and wheel.
3. Remove the left engine splash shield.
4. Use floor stands to support the transaxle.
5. With a jack, slightly take the weight off mount, and Remove the transaxle bracket to transaxle mount upper nuts.
6. Remove the transaxle bracket to transaxle bolts.
7. Remove the transaxle bracket.
Installation Procedure
1. Position the transaxle bracket to the transaxle.
2. Hand start the transaxle mount bracket to transaxle bolts.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the transaxle bracket bolts.
Start with the forward lower bolt and work clockwise to tighten the transaxle bracket bolts to 95 Nm (70 ft. lbs.).
4. Remove the support from the transaxle.
5. Install the transaxle bracket to the transaxle mount upper nuts.
Tighten the nuts to 47 Nm (35 ft. lbs.).
6. Install the left engine splash shield.
7. Install the left front tire and wheel.
8. Lower the vehicle.