84. Cylinder Head Installation - Left

^ Tools Required
- J 45059 Angle Meter





1. Install the cylinder head gasket. Ensure the arrows point towards the front of the engine. The left cylinder head gasket has the letter L stamped next to the arrow.

Notice: Refer to Special Fastener Notice in Service Precautions

2. Install the cylinder head.





Notice: Refer to Fastener Notice in Service Precautions

3. Install new cylinder head bolts.
^ Tighten the cylinder head bolts to 50 Nm (37 ft. lbs.) in sequence. Using J 45059 rotate each cylinder head bolt an additional 120°.