Steering Wheel Control Switch

Steering Wheel Control Switch Assembly Replacement
Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.

1. Disable the SIR System.





2. Remove the retaining screws (1) from the steering wheel radio controls.
3. Remove the steering wheel radio controls (2).
4. Disconnect the electrical connectors from the radio control switches.





5. If equipped remove the screws from the automatic transmission tap shift switches (1).
6. Disconnect the electrical connectors.
7. Remove the automatic transmission tap shift switches (2).

Installation procedure





1. If equipped install the automatic transmission tap shift switches (2).
2. Connect the electrical connectors.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the screws to the automatic transmission tap shift switches (1).
Tighten the automatic transmission tap shift switch retaining screws to 3.5 Nm (31 inch lbs.).





4. Connect the electrical connectors to the radio control switches (2).
5. Install the steering wheel radio controls (2).
6. Install the retaining screws (1) to the steering wheel radio controls (2).
Tighten the radio control retaining screws to 3.5 Nm (31 inch lbs.).
7. Enable the SIR System.