Turn Signal Switch Housing

Turn Signal Switch Housing Replacement
Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.

1. Disable the SIR system.
2. Remove the turn signal cancel cam assembly.
3. Remove the wiper washer switch assembly.
4. Remove the turn signal switch assembly.





5. Slide the turn signal switch housing off of the steering column shaft assembly.

Installation Procedure

Important: The switch mounting bracket must be pressed firmly against the steering column tilt head.





1. Slide the turn signal switch housing onto the steering column shaft assembly.
2. Install the turn signal switch assembly.
3. Install the wiper washer switch assembly.
4. Install the turn signal cancel cam assembly.
5. Enable the SIR system.