Radio Replacement
RADIO REPLACEMENTREMOVAL PROCEDURE
1. Remove the instrument panel (I/P) accessory trim plate.
2. Remove the screws (2) from the radio (3).
3. Remove the radio (3) from the I/P carrier (6).
4. Disconnect the antenna coaxial cable (1).
5. Disconnect the electrical connections (4).
6. Disconnect the digital receivers electrical connector (5), if equipped.
7. Remove the radio (3).
INSTALLATION PROCEDURE
1. Connect the digital receiver electrical connector (5), if equipped.
2. Connect the electrical connections (4).
3. Connect the antenna coaxial cable (1).
4. Install the radio (3) to the I/P carrier (6).
5. Install the screws (2) to the radio (3).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screws to 2.3 N.m (20 lb in).
6. Install the I/P accessory trim plate.