Seat Replacement - Passenger Front EZ Entry
SEAT REPLACEMENT - PASSENGER FRONT EZ ENTRYREMOVAL PROCEDURE
1. Disable the SIR system, if equipped with Side Impact Air Bag (SIAB).
CAUTION: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling Zones. Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs.
2. Position the front bucket seat forward or rearward in order to gain access to the seat adjuster nuts (3).
3. Remove the seat adjuster stud covers (2) and seat adjuster nuts (3).
4. Disconnect the wire harness for the SIAB, if equipped.
5. Remove the front bucket seat (1) from the vehicle.
INSTALLATION PROCEDURE
1. Install the front bucket seat (1) into the vehicle.
2. Connect the wire harness for the SIAB, if equipped.
3. Position the front bucket seat fully forward to gain access to the seat adjuster rear nuts (3).
4. Install the front bucket seat rear adjuster nuts (3).
Hand tighten the nuts.
5. Adjust the seat fully rearward.
6. Verify both lock bars are engaged in the most forward adjustment in the same notch on both of the seat adjusters.
7. Install the front bucket seat front adjuster nuts (3).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the nuts to 28 N.m (21 lb ft).
8. Adjust the front bucket seat to the full forward position and tighten the rear adjuster nuts.
Tighten
Tighten the nuts to 28 N.m (21 lb ft).
9. Install the seat adjuster stud covers (2).
10. Check the front bucket seat for proper operation.
11. Enable the SIR system, if equipped with SIAB.