Power Steering - Pressure Pipe
POWER STEERING PRESSURE PIPE REPLACEMENTREMOVAL PROCEDURE
1. Remove the power steering pressure hose (3) from the power steering pressure pipe (4).
2. Remove the bolt (2) from the power steering pressure pipe bracket (3).
3. Remove the power steering pressure pipe (4) from the power steering pump (1).
4. Remove the power steering pressure pipe (4) from the vehicle.
INSTALLATION PROCEDURE
1. Install the power steering pressure pipe (4) to the vehicle.
2. Install the power steering pressure pipe (4) to the power steering pump (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Fastener Notice
Tighten
Tighten the fitting to 27 N.m (20 lb ft).
3. Install the bolt (2) to the power steering pressure pipe bracket (3).
Tighten
Tighten the bolt to 26 N.m (19 lb ft).
4. Install the power steering pressure hose (3) to the power steering pressure pipe (4).
Tighten
Tighten the fitting to 27 N.m (20 lb ft).
5. Bleed the power steering system. Refer to Bleeding the Power Steering System.