Evaporative Emission Control Canister: Service and Repair

EVAPORATIVE EMISSION (EVAP) CANISTER REPLACEMENT

REMOVAL PROCEDURE




1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the ORVR vent line (1) from the EVAP canister port by pinching both sides of the hose connector (1).




3. Disconnect the EVAP vapor line (1) from the EVAP canister port by pinching both sides of the hose connector (1).




4. Disconnect the 3 EVAP hoses (1) from the EVAP canister (3).
5. Disconnect the electrical connector (4) from the EVAP pressure switching solenoid.
6. Remove the 3 bolts (2) and the EVAP canister (3) from the vehicle.
7. Inspect the EVAP purge system for carbon particle contamination before replacing the EVAP canister.

INSTALLATION PROCEDURE




1. Install the EVAP canister (3) to the vehicle underbody and secure with the 3 bolts (2).

NOTE: Refer to Fastener Notice in Service Precautions.

2. Tighten the EVAP canister bracket support bolts.

Tighten
Tighten the bolts to 19 N.m (14 lb ft).

3. Connect the 3 EVAP hoses (1) to the EVAP canister (3).
4. Connect the electrical connector (4) to the EVAP pressure switching solenoid.




5. Connect the EVAP vapor line (1) to the EVAP canister port by pinching both sides of the hose connector (1).




6. Connect the ORVR vent line (1) to the EVAP canister port by pinching both sides of the hose connector (1).
7. Lower the vehicle.